Issue |
J. Space Weather Space Clim.
Volume 14, 2024
|
|
---|---|---|
Article Number | 18 | |
Number of page(s) | 8 | |
DOI | https://doi.org/10.1051/swsc/2024019 | |
Published online | 30 July 2024 |
Research Article
Ionic liquid coating for charge mitigation of solar modules in space: Electron microscopy on insulating nanosphere lithography patterned surfaces
1
Institute of Physics, University of Rostock, Albert-Einstein-Straße 23, 18059 Rostock, Germany
2
Institute of Chemistry, University of Rostock, Albert-Einstein-Straße 3a, 18059 Rostock, Germany
3
Department of Life, Light & Matter, University of Rostock, Albert-Einstein-Straße 21, 18059 Rostock, Germany
4
German Aerospace Center, Institute for Solar-Terrestrial Physics, Kalkhorstweg 53, 17235 Neustrelitz, Germany
* Corresponding author: sylvia.speller@uni-rostock.de
Received:
28
September
2023
Accepted:
24
May
2024
Surfaces of satellites and spacecraft are exposed to high energy charged particles from the solar wind, especially during space weather events. This can lead to differential charging, which is a common reason for hardware degradation and sensor errors. Solutions like coatings are required to avoid excessive cost and weight. Mimicking the electron part of space-like environments in ultra-high vacuum (UHV) chambers can be achieved by using electrons emitted by a scanning electron microscope (SEM). As a performance test for the discharge capabilities we use the quality of electron microscopy images on otherwise insulating substrates such as glass, structured by nanosphere lithography and coated with an ionic liquid (IL). Additionally, the surface potential was measured by Kelvin Probe Force Spectroscopy. The IL film (BMP DCA) was applied ex-situ and a thickness of 12.8 (±0.8) nm was determined by reflectometry and confirmed by dynamic atomic force microscopy. Such a film of ionic liquid would lead to an additional mass of below 20 mg and negligible additional material costs. The light absorption and influence of ionic liquid coatings on the current output of an actual solar cell were investigated. The results indicate, that these coatings are promising candidates for surface charge mitigation with a high potential for application.
Key words: Conductive coating / Charging mitigation / Ionic liquid / Solar panel / Satellite / Surface charges / Spacecrafts
© M. Wendt et al., Published by EDP Sciences 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (https://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.